負壓稀相氣力輸送系統主要采用負壓羅茨真空泵作為動力源，管道輸送壓力為低真空狀態，管道風速約10-35米/秒,物料在管道內呈霧狀。負壓輸送起點壓力等于或接近大氣壓，終點壓力在-10到-50Kpa之間，管道真空度沿氣力輸送管道逐漸增高。

　　The negative pressure dilute phase pneumatic conveying system mainly uses a negative pressure Roots vacuum pump as the power source. The pipeline conveying pressure is in a low vacuum state, and the pipeline wind speed is about 10-35 meters per second. The material is in a misty state inside the pipeline. The starting pressure of negative pressure conveying is equal to or close to atmospheric pressure, and the ending pressure is between -10 and -50Kpa. The vacuum degree of the pipeline gradually increases along the pneumatic conveying pipeline.

　　負壓稀相氣力輸送系統主要由：氣力輸送風機、取料裝置、管道、緩沖倉、除塵器、卸料裝置、等構成。

　　The negative pressure dilute phase pneumatic conveying system mainly consists of: pneumatic conveying fan, material retrieval device, pipeline, buffer bin, dust collector, unloading device, etc.

　　負壓稀相氣力輸送系統的特點：

　　Characteristics of negative pressure dilute phase pneumatic conveying system:

　　1.輸送壓力低于環境壓力，即使管道破損也不會使物料泄漏而對環境造成污染；設備的制造、維護要求低，工人操作簡單；

　　1. The conveying pressure is lower than the ambient pressure, and even if the pipeline is damaged, it will not cause material leakage and pollution to the environment; The manufacturing and maintenance requirements of the equipment are low, and the worker operation is simple;

　　2.輸送氣體（一般為空氣）直接取自大氣，氣體的溫度即為環境溫度，對熱敏性物料尤為適宜；輸送為連續式、亦可間斷，管道內無物料積存；

　　2. The transported gas (usually air) is directly taken from the atmosphere, and the temperature of the gas is the ambient temperature, which is particularly suitable for thermosensitive materials; The transportation is continuous or intermittent, and there is no material accumulation in the pipeline;

　　3.可實現多點進料，多點卸料；氣體動力源一般為離心抽風機、羅茨真空泵、真空泵，使用壽命長；對輸送物料的適應強，粉料、顆粒料均可順利輸送，環境污染小。

　　3. It can achieve multi-point feeding and multi-point unloading; Gas power sources are generally centrifugal fans, Roots vacuum pumps, and vacuum pumps, which have a long service life; Strong adaptability to conveying materials, both powder and granular materials can be transported smoothly, with minimal environmental pollution.

　　負壓氣力輸送適合輸送以下類型的物料：

　　Negative pressure pneumatic conveying is suitable for conveying the following types of materials:

　　粉狀物料：如面粉、水泥、粉煤灰、滑石粉、藥粉等。這類物料流動性好，但易揚塵，負壓輸送可有效減少粉塵外泄，保持環境清潔。

　　Powdered materials: such as flour, cement, fly ash, talcum powder, medicinal powder, etc. This type of material has good fluidity, but is prone to dust. Negative pressure conveying can effectively reduce dust leakage and maintain environmental cleanliness.

　　顆粒狀物料：如塑料顆粒、糧食（小麥、大豆、玉米）、化肥、鹽、糖等。需注意顆粒的硬度和磨損性，避免管道磨損。

　　Granular materials: such as plastic pellets, grains (wheat, soybeans, corn), fertilizers, salt, sugar, etc. Attention should be paid to the hardness and wear resistance of particles to avoid pipeline wear.

　　輕質物料：如泡沫顆粒、羽絨等。負壓輸送可利用較低的氣流速度實現輸送，減少對物料的損傷。

　　Light materials: such as foam particles, down, etc. Negative pressure conveying can utilize lower airflow velocity to achieve conveying and reduce damage to materials.

　　有毒、易燃易爆物料：如化工粉末、金屬粉末等。負壓輸送系統密閉性好，可降低物料泄漏風險，提高安全性。

　　Toxic, flammable and explosive materials: such as chemical powders, metal powders, etc. The negative pressure conveying system has good airtightness, which can reduce the risk of material leakage and improve safety.

　　高附加值物料：如鋰電池材料、納米材料等。負壓輸送可減少物料與外界環境的接觸，保護物料品質。

　　High value-added materials: such as lithium battery materials, nanomaterials, etc. Negative pressure conveying can reduce the contact between materials and the external environment, protecting the quality of materials.

　　不適合負壓氣力輸送的物料：

　　Materials not suitable for negative pressure pneumatic conveying:

　　高濕度或粘性物料：如濕污泥、黏土、糖漿等。這類物料易結塊，可能導致管道堵塞。

　　High humidity or viscous materials: such as wet sludge, clay, syrup, etc. This type of material is prone to clumping, which may cause pipeline blockage.

　　易碎或熱敏性物料：如膨化食品、脆性晶體、某些藥品等。負壓輸送的氣流可能對這類物料造成破碎或變性。

　　Fragile or heat sensitive materials: such as puffed foods, brittle crystals, certain drugs, etc. The airflow of negative pressure conveying may cause breakage or denaturation of such materials.

　　超大或超重顆粒：如直徑大于50mm的礦石塊等。此類物料不適合氣力輸送，需采用機械輸送方式。

　　Oversized or overweight particles: such as ore blocks with a diameter greater than 50mm. This type of material is not suitable for pneumatic conveying and requires mechanical conveying.

　　注意事項：實際應用中，需根據物料特性（如粒徑、濕度、流動性）和輸送需求（距離、流量）選擇合適的輸送方式。對于特殊物料，建議進行物料試驗，以確保系統設計的準確性。

　　Attention: In practical applications, it is necessary to choose the appropriate conveying method based on the material characteristics (such as particle size, humidity, fluidity) and conveying requirements (distance, flow rate). For special materials, it is recommended to conduct material testing to ensure the accuracy of system design.

　　本文由  負壓氣力輸送 友情奉獻.更多有關的知識請點擊  http://www.sctcjt.com/   真誠的態度.為您提供為全面的服務.更多有關的知識我們將會陸續向大家奉獻.敬請期待.

　　This article is a friendly contribution from negative pressure pneumatic conveying For more related knowledge, please click http://www.sctcjt.com/ Sincere attitude To provide you with comprehensive services We will gradually contribute more relevant knowledge to everyone Coming soon.